RetroArcade.us Crane Machine Prize Sensor for RA-CRANE-KIT, Prize Sensor and Prize Sensor Cable

RetroArcade.us Crane Machine Prize Sensor for RA-CRANE-KIT, Prize Sensor and Prize Sensor Cable

Prize Sensor Specifications:
Length: 7.6250 inches
Width: 2.0000 inches (without mounting holes)
Width: 2.8750 Inches (with mounting holes)
Height: 0.9375 inches

Prize Sensor Cable Specifications:
Length: Approximately 3 feet 6 inches

Installation Instructions:
The white connector plugs into the crane prize sensor.  It is keyed to only plug in one way.  The pinout is etched on the crane prize sensor where this white connector plugs in letting you know which wire is for what purpose.  The loose wires then get connected to the crane PCB through the wiring harnesses plugged into J4(P4) and J3(P3).  They push and snap into these existing white connectors as follows:
GND (Ground) – J4(P4), PIN 1
12V (12 Volts) – J4(P4), PIN 9 (PIN 9 may have an existing wire.  If so, use PIN 8)
S (Signal) – J3(P3) PIN 1

NOTE: This item includes both, the crane prize sensor (RA-CRANE-PS-SENSOR) and the crane prize sensor cable (RA-CRANE-PS-CABLE).

UPC: 665570199747

SP: crane machine kit, crane machine, crane gantry, claw machine, claw game, the claw machine, arcade machine, RA-CRANE-KIT, prize sensor, sensor, cable