RetroArcade.us Crane Machine Prize Sensor Cable for RA-CRANE-KIT, Prize Sensor Cable Only

RetroArcade.us Crane Machine Prize Sensor Cable for RA-CRANE-KIT, Prize Sensor Cable Only

Specifications:
Length: Approximately 3 feet 6 inches

NOTE: This is only for the prize sensor cable.  Prize sensor is NOT included.

Installation Instructions:
The white connector plugs into the crane prize sensor.  It is keyed to only plug in one way.  The pinout is etched on the crane prize sensor where this white connector plugs in letting you know which wire is for what purpose.  The loose wires then get connected to the crane PCB through the wiring harnesses plugged into J4(P4) and J3(P3).  They push and snap into these existing white connectors as follows:
GND (Ground) – J4(P4), PIN 1
12V (12 Volts) – J4(P4), PIN 9 (PIN 9 may have an existing wire.  If so, use PIN 8)
S (Signal) – J3(P3) PIN 1

UPC: 709402207696

SP: crane machine kit, crane machine, crane gantry, claw machine, claw game, the claw machine, arcade machine, RA-CRANE-KIT, prize sensor, sensor, cable